Geissele SMR 416

Add to compare

Arisaka Defense Indexer for Geissele SMR 416

Out of stock

$35.00

The Arisaka Defense Indexer is a continuation of our low profile, minimal control accessories. It was developed due to end-user demand for a Geissele SMR 416 version of our Finger Stop for Picatinny rails, and features a slim front-to-back profile and slight radius across both faces.

The Indexer can be used in a variety of ways, but the main intent is to place it between two fingers (usually index and middle). This typically places it further forward on the handguard, which also means it doesn’t get in the way when transitioning to kneeling or prone shooting positions, where most people move their support hand towards the rear. Used in this manner, the Indexer makes it much easier to pull the rifle into your shoulder and maintain control while shooting.

  • Wider, flatter profile of the Indexer functions very well as a hand stop or barricade stop, and also works as a forward limit to prevent your fingers from slipping off shorter handguards onto a hot barrel or suppressor.
  • Height: 1.0″, Width: 0.58″, Length: 2.2″
  • Weight: 0.9 oz
  • CNC machined from 6061-T6 aluminum and MIL-A-8625 Type III hard coat anodized.
  • Requires an IP25/T25 Torx wrench for installation (not included). Made in the USA.
Select options This product has multiple variants. The options may be chosen on the product page
Add to compare

Arisaka Defense Offset Scout Mount for Geissele SMR 416

Out of stock

$65.00

The Arisaka Offset Scout Mount attaches directly to the threaded inserts on the Geissele SMR 416, eliminating additional Picatinny rails and Picatinny mounts.

  • Three lateral light positions allow the user to tuck the light closer to the top rail or gain clearance around top rail mounted accessories like laser illuminators.
  • In particular, there is enough clearance for the larger Modlite OKW and PLH heads to fit next to the NGAL, LA-5/PEQ, AN/PEQ15 and ATPIAL-C.
  • It will also allow lights to clear the QD lever on the Steiner DBAL I2, A3, and D2.
  • Allows fore and aft adjustment so the user can fine tune the location of the light to their setup.
  • Length: 2.20″
  • Weight: 0.9 oz including hardware
  • CNC machined from 6061-T6 aluminum and MIL-A-8625 Type III hard coat anodized.
  • Includes all necessary screws. Requires IP25/T25 and IP20/T20 Torx drivers for installation (not included).
  • Made in the USA.
Select options This product has multiple variants. The options may be chosen on the product page