The Zev Technologies™ Generation 4 Magazine release for the Glock® is constructed from Billet 6061 Aluminum and Mil Spec hard anodized.
It has a checkered non-slip face for a more tactile engagement surface. The contact point on the mag release face is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes. The Mag Release takes minutes to install with the use of needle nose pliers and a long shaft, slim, flat head screwdriver.
Note: It is easiest to remove and replace the factory Glock®; Mag-release Catch Spring for the magazine release installation. Then installing it back in its pin position after you remove the factory unit and replace it with the ZEV™ component.
ZEV Parts always incorporate design, feel and performance.
4th & 5th Gen Compatibility
- Glock 17
- Glock 19
- Glock 22
- Glock 23
- Glock 26
- Glock 27
- Glock 31
- Glock 32
- Glock 33
- Glock 34
- Glock 35
- Glock 37
Takes minutes to install with the use of needle nose pliers and a long shaft, skinny flat head screwdriver Note: it is easiest to remove and replace the GLOCK Mag Catch Spring for the magazine release installation. Compatible with Gen 5 Models